Aqualinkd not reflecting controller status

[sts098]

I am running a pda-ps8 combo with rev 7.1.0. Running current development version 2.4.1 dev 0.1. My system has the pda-ps8, Jandy 18 channel RF receiver, IAquaLink, and a Jandy variable speed pump.

Operating well, not seeing checksum warnings in Aqualinkd manager.

Operating well, until schedule in pda turns off pump. At that point, Aqualinkd/manager still shows pump on (bright blue). Speed shows last speed, watts drops from 980 or so, and shows 4 (likely watts to keep board energized).

Similarly, turning pump off through IAquaLink while cleaner is running (message in IAquaLink says pump will remain on while cleaner is running). Aqualinkd shows cleaner on delay (filter is actually on delay). Turning off cleaner in IAquaLink, shuts down cleaner, then filter pump. Aqualinkd still shows cleaner status delay, pump on speed 3450 (cleaning speed) again, watts on 4, pump on.

Seems Aqualinkd pump off status went sent from pda controller and not understanding delayed device.