Figg

Same problem here. Unfortunately, that's the only way I can get my down sensor table to show.

I'm having this issue too. No matter what I change, I can't get it to show Mbps properly.

Anyone figure this out yet? Pretty much makes this pointless for us to use at this point. We have 20 sites we want to monitor bandwidth at, and while I...

Figured out how to fix this based on another user's comments to try the factory sensor. I created a factory sensor on my firewall device (or whatever device you're wanting...

I did * 8 originally, but for some reason it didn't work for me (makes sense to multiply by 8, right?). Whatever works I guess. The down and warning sensors...

Anyone know if this was fixed yet?

alxshr - I added a factory sensor to my firewall in PRTG to monitor internet throughput, and can't get it to display in Mbps in Grafana. Here is an example...


Okay, this sounds stupid. On my old setup, I have regular zigbee and z2m working at the same time. Is that not supposed to be the case? Should I have...

thank you - I did this, and got it working. Stupid question again now - are zigbee routers not supported or work as traditional routers? I have a few bulbs...