sargonphin
sargonphin
Sorry if I upset you guys with this Wifi stuff, that wasn't my intention! 😰
Could you be more precise about what's not working? Also, try a minimal configuration from a fresh configuration file (just enough to run homing) and see if homing works. Enable...
Could you enable `#define DEBUG_LEVELING_FEATURE` in `Configuration.h`, compile & flash the firmware, then run `M111 S247` and then `G28`? This will output a whole lot more debug information on the...
Amazing rework of my sloppy unskilled coding there! Thanks a lot :D Indeed the idea started with sensorless homing but it eventually skewed towards preventing damage in case of a...
OK just tested and behavior is the same on my printer. Seems like it's ready to merge, although while reading the code, I noticed a small issue with quick_home If...
I fine-tuned the sanity checks to check for all possible configuration of X, Y and Z (multi-stepper per axis) and added a sanity check when homing current is not defined...
Any update regarding the merging of this PR? It has been implemented on my printers for a while now and couldn't find any issues with it so far ^_^
Causes my board to boot loop on a clean config except for the TMC drivers
> I can confirm I have no issue either powering a RPi4 through the Octopus MAX EZ's USB-A port. I'm using a very short (10cm) A-to-C cable, which might help....
We have done some tests now. I would like to add that the 5V 5A that is being advertised is not about the USB power, but the overall 5V rail...