Ryan Johnston
Ryan Johnston
This is a Pixhawk 6c Issue Tracker Tested on various versions of Main • The i2c port doesn't pickup any devices (when running i2cdetect). This is because it is setup...
This is on Daily and a Mac. When adding a new Comm link if I hit advanced, enable flow control (it is enabled on the actual hardware) and select 1...
This may be similar to the issue posted but not clear on that and it’s a quart on rather than an issue. Can you plug in an esp32 (running drone...
On any browser from iOS, no graphs past raw angular speed (gyroscope) are viewable. It just sends you back to the top of the page. I’ve tried multiple iOS browsers,...
On Main when RC RSSI is plugged in it doesn't always get picked up and displayed. Multiple reboots were needed to get it picked up. Tested a known setup on...
Fresh install of macOS Sonoma 14.1 Fresh install of PX4 toolchain and related. Clone of Main (also tried RC2 because I had it pulled). Gazebo (classic) starts fine (just invoking...
Sees the stream but no codec found: Any idea? Input #0, mov,mp4,m4a,3gp,3g2,mj2, from '/files/good2.mov': Metadata: major_brand : qt minor_version : 537199360 compatible_brands: qt creation_time : 2024-02-06 17:22:08 Duration: 00:03:29.81, start:...
Newer Macs is firstly subjective but in the tests I did, as I rolled back the hardware and software of the Mac computers being used it started working again. Problem:...
On Android and the OpenDroneID app I can see the Emergency Status text and type correctly but on iOS and DroneScanner I get a series of numbers in Operation Description....
In the 1.14 firmware (likely previous ones as well) it requires an operator id otherwise you get the op_id arm error. Since only required in EU jurisdictions some type of...