rwarshauer

# Overview Trying to add mix step with single channel pipette in PD doesnt work # Steps to reproduce 1. Open PD 2. Make protocol 3. Add single and 8...

6.0 Feedback: Robot disappears after changing name

4

### Overview When robot name is change robot disappears ### Current Behavior Robot disappears ### Expected Behavior Robot goes unavailable then becomes available again ### Steps To Reproduce 1. Go...

### Overview The menu that slides out when trying to run a protocol seems choppy ### Current Behavior Slide out tray comes out in a few motions ### Expected Behavior...

6.0 Feedback: Robot is not homing after canceling our of 'Detach pipette'

3

### Overview After canceling a detach pipette command the robot lifts the pipettes but does not home the robot ### Current Behavior Robot does not home ### Expected Behavior Robot...

# Overview In the H/S module card if its heated above 49 degrees a caution banner saying deck is hot is shown. This is not shown on any other heating...

### Overview Calibration of tip lenght got stuck on second step and would not move forward, this only happed on a P300 Gen2 Multi ### Current Behavior After picking up...

### Overview After finishing a run all the time values per step show but the last two steps. ### Current Behavior Protocol finishes but last two steps have no times...

### Overview After a run is done a green banner shows up says run is complete with an x to dismiss. Clicking X does not dismiss ### Current Behavior Currently...