rsuzano
rsuzano
> Hi @per1234, thanks for your suggestion. > > A long time ago, we set up TravisCI which built the examples. But this is not working anymore and doesn't make...
Hi @3DSmitty , how are you? Did you figure out if it's possible to use the tmc2209 in UART mode on the TinyBee? Even with some jumpers soldering?
Hi @3DSmitty your board arrived?? My thermistor short circuited at heatblock and fried D7 diode, it's part of power circuit, everyting works, but the D7 diode have a hole on...
> That's the only information it says there. C2  Thanks @LouisR21 ... that simbol after C2 it's what?? only the manufacturer logo?
Thanks, I found the datasheet, it's a zener diode
> @rsuzano So.. I just discovered Marlin does not support software serial on ESP32 which is needed for TMC2209 UART mode. We might have to wait until Marlin supports this...
The sum of inattention, fatigue and bad luck.... I plugger on the LCD of the ANET Full graphics that I already had, and the + and - is inverted, it...
Please, I need to... My thermistor short circuited at heatblock and fried D7 diode, it's part of power circuit, everyting works, but the D7 diode have a hole on it...
Hi, sorry for not find the issue #26 before open this. I'll try that solution. Thanks
Ok, so, can you please give me more details about what's the idea of the config "xdivs" and "ydivs"??