ESPHome-OpenTherm

ESPHome-OpenTherm copied to clipboard

Usage of `id()` for custom components is also referenced here: https://esphome.io/custom/custom_component.html The firmware would crash for me if I directly referenced `opentherm`, since the `switch` would get initialized earlier than...

gmta

HA - ESPhome config

29

Hi I managed to flash it but when I go to add it on ESPHome it keeps giving me an API error.  ps: to flash got needed to coment...

marcos-acpc

Can't change the state

3

Hi @rsciriano , I tried yuor code, compiled and uploaded on a D1 mini. When the d1 starts, the boiler starts to heat but if I switch it off, the...

cecet23

If temperature_sensor won't update frequently PID won't update its values

krzysztofsk

unstable operation

1

The following frequently occurs, always for a brief moment: - Return temperature goes to -1°C - Hot water measurement goes to -1°C - Heating water measurement (boiler temperature) goes to...

bartmarchand1

No interlock hot water and PID climate controller

8

Hi, When PID climate controller is in "heating" mode, the pump is circulating water in the radiators. When hot water is required, the three way valve shuts but the pump...

ShurikenGitHub

hot water BAXI

9

I can't set the temperature of hot water, the hot water heating mode is turned on but the water is not heated

ananyevgv

Setting upper and lower limits in boiler

6

Hello My boiler have limits 45-85C. But i want to set in opentherm PID settings limits 50-75C for water in boiler. How i can set upper and lower limits in...

bigbrother72

Setup

3

Hi got this flashed a week a go dont have the new boiler yet (@rsciriano thank you so far for solving other questions i have asked) but just getting ahead...

electricfire

Crash and reboot when opentherm bus isn't connected

8

after flash i got this in logs view i using wemos d1 mini and esphome flasher ``` Hard Resetting... Done! Flashing is complete! Showing logs: [22:48:11][I][logger:170]: Log initialized [22:48:11][C][ota:366]: There...

sag3ll0