rrobinett

After at git clone: rob@Wsprdaemon-Thinkcenter:~/kalibrate-rtl$ ./bootstrap ./bootstrap: line 12: libtoolize: command not found rob@Wsprdaemon-Thinkcenter:~/kalibrate-rtl$

Internet-pi not accessible after moving to new ISP

2

My Internet-pi was running well on my Pi4b running buster until I changed to a new ISP with router that assigns the Pi a different LAN address. Now I get...

Installation failing on Pi4b running "buster"

5

This is a pretty vanilla buster installation and run as user 'pi', but I get this error even after reboot and restarting the docker service: > fatal: [127.0.0.1]: FAILED! =>...

In addition to the noisy audio problem I describe in an earlier issue, I am unable to accurately set the tuning frequency of my RTL-SDR V3 when using rx_fm. Using...

Following a suggestion in another thread, I have been able to hear USB audio by disabling a signal sample scaling loop in sx_fm. However the sound produced by rx_fm has...

No sound in output

2

I am trying to replace rtl-fm with rx_fm on a Raspberry Pi 3B in order to benefit from improved tuning frequency accuracy and access to all Soapy-supported devices. Running 'rtl_fm...

Is 'master' now the preferred version?

3

I have been installing v0.1 in wsprdeamon clients. With this merge, is 'master' the best for me to install? It would be helpful if there were a '-V' flag which...

Would it be possible to signal the Kiwi to change frequency without restarting the session?

5

When the wsprdaemon schedule feature needs to change the receive band of a receiver, it currently kills the running session and starts a new kiwirecorder session on the new band....