robinhellmers

I just opened it up, made sure that the contact points were at the right place and I still have an issue. Seems to just be an issue with the...

Hi, I can confirm that this problem still exists after doing a factory reset (within the Ralim firmware). Here is also a video showcasing my problem, I just activated extra...

> I think I might have seen a similar thing on a Pinecil with some of the tips (some came with the Pinecil, some are third-party TS100-compatible tips). This was...

I just flashed it with **V2.10.1** and it solved the issue. It overshoots with 30 C but then goes down and stabilize at the set temperature. This is without doing...

I don't have a thermometer, but about 20-24 C room temperature. Here's **V2.13**, no heat up before. Neither calibration of temperature or voltage: - v2.13.28736CB, 31-13-20 - HW G 171...

@Ralim @discip Sorry for not responding. I am a bit short on time as I am in my final part of my master thesis. I will absolutely provide the data...

Hi, The issue does still remain with V2.18. The initial drop does not occur anymore, but the overshoot and swinging does. I have calibrated both voltage and temperature. Here I...

@thrawn86 Have you any updates on your end? As I would like to use the Hakko tips I have, I am considering buying the Pinecil V2 and try it out.