riogrande75

I have to correct my statement from above: It is still possible to install any software with the TFTP method, even with brand new 2018 bootloaders! Also UART is ok,...

I did not create it by myself. I let a tool do it. Pls. check [https://ipcamtalk.com/threads/dahua-ipc-easy-unbricking-recovery-over-tftp.17189/](url) for a full tutorial how to flash via TFTP. Then edit commands txt accordingly:...

Same here with brand new firmware for VTO2000A V3.300.0000001.0.R.20180105. Caused by the changes in the partition layout, the scripts didn't work anymore. I had to change configs/VTO2000A.py accordingly: _from .config...

My VTO2000A is already installed and works quite fine. To be honest, I don't wana fu** it up. Maybe someone who did not yet install it, can try it. But...

Ok, thx. I'll investigate commands further. Some help with logfiles from other users would be very helpful. Can any of the MPI10k users pls. send me the inverter's reply for...

After a long research I've finally found out, how PI17/PI18 inverters (10k, 15k) get the BMS values. Conclusion: You simply need to send a ^D054BMS... string periodically to the inverter....

Issue command "config all" - there you should get any password you've set either on the VTH (numbers to login on display) or password of your corresponding VTO.

Any update on the LED issue? I've flashed my S20 with this nice fw and included it in HA. If LED's would work as well like @NesporBellisRM desired, it would...

In fact BMS comms to MPP/FSP/Voltrinic hybrid inverters (10/15k) is quite easy. I run it with my php scripts since more than 2 years witout any issue. All you need...

The link doesn't work anymore. I used a ESP32 that reads data from JK via BLE and pushes these values on a mqtt server via WiFi. Everything is described here...