Rajko Zschiegner
Rajko Zschiegner
Please read the complete instructions! After connecting the 2 pipe parts the SDS011 and the ESP8266 should be in the upper part of the "∩". Only a very short part...
The 2 pipe parts are identical. So the second one is also a 'DN 75 87°'. One end of the pipes is slightly larger than the other so that you...
@SFotonium The DHT22 was registered in our database but not the BME280. I have changed the DHT22 entry to a BME280 so the data should now be shown for ID...
We are using the I2C interface. So the pins are D3 for SDA and D4 for SCL.
@Pdw112 this should be 'airrohrcfg' as mentioned by @Nealux.
Could you please check where you pushed it to? I can't see a pull request for this.
At the moment the ESP32 code is very beta and may not really compile or even work. One of the benefits of the ESP32 would be the hardware serial ports....
@Truffaldino13 I have changed the sensor type from DHT22 to BME280 on devices.sensor.community. Now you should see the sensor on the map.
I'm not sure, but I remember some power problems could cause this.
We use graphana for the graphs. The math functions there are very limited. But for the average values we need the logarithmic average of the dBA values. So we are...