reynolds087

https://user-images.githubusercontent.com/32722984/194782467-b9653189-6806-4a08-850b-604ca6b0986b.mp4

I disconnected the disable pin and it does not spin backwards anymore. But it still goes farther than expected based on the lead of the screw and the steps per...

@MitchBradley , I tried that just now, but it's still not traveling the expected distance. It's like there is a step per mm mismatch, but I don't see how there...

Ok, thanks. Let me know

Thanks, @MitchBradley . Can I just upgrade to v3.6.3 to fix it, or do I need to change the configuration of certain pins?

  https://user-images.githubusercontent.com/32722984/194969935-a37e9d79-2609-479d-9aad-134b5ee8139d.mp4

Thought I was still having an issue, but I think it's good now.

It's a lot smoother. I just need to check the distance.

It still runs backwards when the disable pin is used. I never had that problem with GRBL_Esp32. It's strange that I do now without any significant mechanical changes to the...

I'm not sure what UGS uses, but in fluidterm, I've been testing with $J=g91x10f100