Richard Cornwell
Richard Cornwell
Make sure you are not getting any command errors. Some of your options are wrong!
I am using the test case above. Make sure that you start PDP6 first, and that the KA connects before using continue to do test. Interesting on KL restore works......
Not sure if it can work either way. The KA needs to connect to the 6, if the 6 aint running it can't connect.
Feel free to add it. I will pick it up on the next release.
I believe you can use sim_message. Why output to stdout, this was not the console?
This sounds exactly like LP10... perhaps they just moved it to another address?
If they are that similar then add in a second unit to LP. Set it disabled and give it the address of the new printer.
Yes second device and DIB will be required. If CONI/CONO bits are the same, I can add it if you want. If not, just let me know what the differences...
What does start/stop motor do? What does image mode do? Looking at printer code this might be a bit more complex.
I think it will be a new device since the printer has some specifics that make it harder to add more units.