linux

linux copied to clipboard

### Describe the bug Hello I have a USB 3.0 NATEC NKZ-0448 3.5" sata hard drive enclosure With Asmedia ASM235CM Chipset In a Raspberry Pi 4B 4GB rev1.4 With latest...

symbios24

### Describe the bug After updating raspberry pi software using `sudo apt update` & `sudo apt upgrade` wifi stopped working. Wlan0 isn't showed in ifconfig and "wireless and wired settings"...

geargoose

rockchip patches not correct

3

### Describe the bug Looking at the 5.18 branch of this repository. The checkin is d9d409987bf466c52599eda0254c0c3a8d950b1f. This contains e.g. changes to drivers/media/platform/rockchip/rkisp1/rkisp1-isp.c. Many definitions to "state" are duplicated in the...

laroche

USB issues with dwc_otg since a few 5.15 patch levels

2

### Describe the bug Recently I've started to notice some flooding of the logs when using a USB WiFi dongle on a Raspberry Pi 3 B with a 32 bit...

spockfish

A bulk read of slave devices of a `w1_bus_master` should be possible by writing `trigger` to the `therm_bulk_read` entry in the device tree of the bus master. However, the entry...

herby74

Pi4 crash when using 2nd USB3 device when booting from USB3 SSD

24

I use the Pi4 booting with a USB3 connected SSD. This works nicely, but when I connect in addition an external USB3 HDD to the USB3 port, then the system...

poliboy

RPi4: WiFi client crashes often (brcmf_fw_crashed: Firmware has halted or crashed)

154

**Describe the bug** WiFi client stops working and does not recover (Cypress firmware crashes). This happens to my RPi4 almost every day and I must reboot to recover it. After...

jgilles

I2C clock-stretching bug

45

### Describe the bug I'm having intermittent problems with the RPi4 when it performs I2C reads on devices (like UCD9081 texas) that use clock stretch. This apparently affects the Raspberry...

kaedros

Linux 5.15.32 sometimes failing to initialize USB

4

### Describe the bug Hi! I have built a yocto-image for my CM4, and I'm using linux 5.15.32 from this repository. The CM4's USB2 lines are connected to a FE1.1S...

teletypo

Add new V4L2 controls for quad Bayer sensors

7

@naushir @6by9 I've been looking at one of these "quad Bayer" (some manufacturers call them "tetracell") sensors. These typically have a binned mode of operation where you get a standard...

davidplowman