R.Molot issues

Repositories
Issues
Comments

Results 2 issues of


                                            R.Molot

Wrong extrusion suggested as spacer on page 17

Page 17 calls to use Extrusion E as a spacer. Extrusion E is horizontal and spec-dependent. It is OK on 250 spec, as the E has 330mm, but on 300...

Cable Cover is a bit too thin in one place.

In one of the interviews about Galileo2 I've heard, as far as I remember, that if should be printable using 0.6 nozzle and carbon fiber filament. And it almost can....