radius75
radius75
I have now tested both my test programs on the official fw3.11 The first one prints 8 pages correctly (Basic2.0 and Jiffy) :) The second program (which should also print...
I ran print160.prg again on Basic2.0 and waited about 15 minutes. No response, only the reset button works. Ultimate2+ cartridge only connected to IEC Bus. My print configuration is in...
I checked that copy of the original laser basic 1.3 on the g64 starts up correctly. U2+
I tested it yesterday on u2+, C64c, PAL, 1571, d71 (340KB), Copied from d64 file by file. The demo sometimes runs to the end. And sometimes it's just a black...
Out of 4 attempts failed to run this demo. Black screen from start and no sound.
demo on d64 in emulating 1571 doesn't work for me. demo on d71 formatted to 170 or 340 KB (mode M0 or M1) works fine until the end, but I...
I have observed strange behavior When the demo is run on 1571 (no matter if d64 or d71) and the screen stays black Entering/exiting the u2+ menu via the middle...
https://mega.nz/file/nNRjSAAK#4kMiViLt11vXyMKqFcbMh5d374UnJrr1URVa1ibwtj8 Here the demo was blocked at the very beginning, the first time it was unlocked, then not anymore. With my other trials and tests, after such unlocking, the demo...
I ran tests on three types of floppy disks, formatted in M0 and M1 modes on 1571 emulation. d64-m0.d64, d71-m0.d71, d71-m1.d71 All tested on one trial. I ran the demo...
It doesn't seem like this demo requires a full-disk copy. I copied to formatted d64 file by file and work without problem in 1541 U2+. I won't be surprised if...