subg_rfspy

subg_rfspy copied to clipboard

How do I change the frequency to 433Mhz for use with Omnipod?

1

I'm using Omnipod in the US. On the Loop websites there's a screenshot of the settings page and it shows 433MHz - how do I do make that change? Out...

stephenclong

If I run listen_omni.py (rileylink & FT232 dongle ) everything seems to work for a minute or two and then I get a continuous stream of the following response PacketResponse("989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898989898")...

danyocom

In the serial.c code ``` uint16_t serial_rx_word() { return (serial_rx_byte()

ecc1