przemu

mcu is STM32F103RCT6. 

that's good, now you have free sample for developing OpenDPS. :)

Mine is a bit bigger, case is from mini ITX PC, I have 3D printed black frames for display, and adapters for micro-switches buttons.    

Yet another one in caterpillar style, it's about 40cm long. This time 3D printed case, inside is a some space because I use common mode choke with big capacitors to...

nope, I don't think so, DPH series are buck-boost converters, they differ from the step down buck DPS series. Where did you find DS5005?

dunno, DPH5005 pcb looks like DPS5015 but it's different. you can replace orginal STM32f1 with new one bought from local store and try to upload new firmware, just in case...

Same issue here, DPS5015 rev 2.3, checked two usb to serial boards, one from DPS kit, second ftdi232, commands are working without errors, but I can't upload new firmware. Maybe...

Hi, somehow for me more convinent and accurate is manual calibration, check commands like: ./dpsctl.py -d /dev/ttyUSB0 --screen settings ./dpsctl.py -d /dev/ttyUSB0 -c A_ADC_K=your calibration factor ./dpsctl.py -d /dev/ttyUSB0 -c...

Hi, for 10 A current at 20 V you will need 2 Ohm 200 W resistor, but for short time, like few seconds measure probably 50 W will be enough....