pmelevende

Hi Ryan, Is the stepper still turning the lead screw correctly? If so, the encoder is working fine. Thanks Pauly >

Hi again Ryan, In that case, I'd suspect either the encoder or TI board interface. As you have checked the encoder output, and its not changing, I'd suspect it (or...

Hi Les - Open the IDE, Open the project in the project explorer, Select 'els-f280049c' as active project, then click on the little hammer icon. That should build the project...

Hi James, Maybe then, it's close to time to 'add some value' :-) (not that it isn't already extremely valuable!) >

Hi again, It's been a while but something was nagging me in the back of my mind that I'd updated and got it to work - So - I checked...

HI Frostheaven, Yes - Check 'Direction and Enable' on this page https://github.com/clough42/electronic-leadscrew/wiki/Configuration-Settings Thanks Pauly >

HI again Bob No you will be fine. Even if you mess up somehow, I'd assume that 270 ohm resistor on the enable line is there to protect you :-)....

HI - It's embedded in the code - see the path, electronic-leadscrew-1.4.00\electronic-leadscrew-master\encoder-sim\EncoderSimulator

Bump

Hi @tarwy1 In the 'C2000 Piccolo F28004x Series LaunchPad Development Kit (Rev. B)' user guide here; https://www.ti.com/lit/pdf/spruii7 ..theres a bunch of examples referred to as well.. Search that doc for...