peschman

Given the problems that might be caused by relying on upload_enabled: false, I think the -t or other char to indicate running in test mode would be the best solution....

I do a lot of testing using secondary or tertiary streams of IMX-291, where the primary stream uploads to GMN, but the testing streams, lasting all night, or all day...

Sorry, I had overlooked the earlier messages that argued against using upload_enabled: false In my testing case, I'm testing MultiCam, so I can't just set the ID to XX0001. I...

How about this: test for camera ID starting in XX, XX0 or XX00 rather than just for XX0001? In that case, I could use XX0001, XX0002, XX0003, and other XX000?...

Luc has discovered the perfect work around to cancel authentication. Commenting out the rsa parameter in config eliminates the delay: ; Path to the SSH private key rsa_private_key: ; ~/.ssh/id_rsa...

I will try to close the issue -- when I looked earlier today, I could not find it under open or closed. I will check again tomorrow as it's late...

I need to clarify the context for the problem 1. flash a new microSD, copy over .config and mask but forget platepar 2. run first night capture, realize platepar is...