pascallanger

The payload is 5 bytes long so definitively something new. Steering 68 8A...69 F8...6B 8C -> 08A...1F8...38C => 1F8 center should probably be 1FF but even then the end points...

Test the protocol SLT/V1_4CH available here: https://downloads.multi-module.org/latest-test/

Ok since the RX receives the bind packets it looks like the problem is instead around the module ID. Can @Macgyver46 and @Pencilvestr share your Global IDs using the MultiConfig.lua...

@Macgyver46 it's easy, just go to the scripts, run the multiconfig.lua script and share a picture of the screen.

Original radio ID: F4 71 8D 01 -> OK TX16S ID: 65 50 FE 30 -> OK MT12_Mac: 29 F9 BE 3E -> OK MT12_Pen: 57 0B 31 A5 ->...

Flickering usually means packet loss so that's bad. If you could identify the ones with flickering. Was there a lot of them? I was not anticipating such RF channels issue....

Above 31 is not needed as it will have no effect at all, basically using your original ID unchanged...

If you have a saleae compatible logic analyzer (less than $10 on ebay), hook it up to these 8 pins:  Don't forget to connect GND as well.

We don't see anything anyway... Connect a logic analyzer on the 8 pins I've pointed out earlier.

Please use logic 1.2.14 instead of 2.xx It looks like the RF module was not plugged to the motherboard and therefore the CPU went in a loop not finding what...