ollo69
ollo69
This is probably due to some constant rename, You just need to delete the existing entity and enable again in device page.
@johanneswilkens, This PR is merged and closed, do not post here. Use issue #332 to discuss about this. Thanks.👍
Can you please attach diagnostics?
The bot used to close the issue should just ignore the issue with label "Feature Request", I do not understand why this configuration doesn't work!!!
> "Feature Request" != "Feature Requests" I think that I review 100 times the script, and I didn't see this stupid errors. Thanks a lot.
Water Heater support was introduced by PR #420 on December 9, 2022
It could be possible run this unit test inside the dev container that I just added to the repo? Can someone review this tests based on current development status?
Ok, I re-open this, but is unclear why `Run-state` and `Pre-state` are always the same. Just trigger the sensor based on your suggestion is not really correct: a power failure...
I reopen this issue because I made some changes to support `run_completed` for these devices that do not provide `end` state. Can you please test is last release fix the...
@Trilis29 , thanks for you feed-back, but please test last release ([v0.38.3](https://github.com/ollo69/ha-smartthinq-sensors/releases/tag/v0.38.3)) because I review a little bit the code from previous one and I just want to be sure...