ogland
ogland
Well an updated solved that problem, but I can't run it ``` pi@litezero:~/Bed_Distance_sensor/klipper $ ./uninstall.sh -bash: ./uninstall.sh: Permission denied pi@litezero:~/Bed_Distance_sensor/klipper $ sudo ./uninstall.sh sudo: ./uninstall.sh: command not found ```
You can do this yourself very easily in your end gcode.
I very much want this too.
What I found is that with fanmux, the fan targeted with M106 without the P should be current extruder, but with T parameter in toolchange gcode, the M106 command fires...