Guyamor Anton Ajit Ananthadevan
Guyamor Anton Ajit Ananthadevan
but the ftdi bridge has only 1 usb, how do yo connect to the bl602?
pinout? 
oh the tx0, rx0 pins are on the breakout... this is easier than I thought, same code to flash... just different bridge!! kudos for impl. the auto-reset!! :+1: ``` ~/Downloads/blflash-linux-amd64...
DTR -> EN RTS -> D8 is right?
could you please add instructions on how to do this in Readme? many thanks
hi, it doesnt even program through the ftdi, even if i manually press the button? i get the same error!
okay success! i had to desolder out the onboard usb ic...
actually it was already in bootloadre mode (but can flash). i think the following change is necessary: ``` pub fn reset_to_flash(&mut self) -> Result { self.serial .reconfigure(&|setup: &mut dyn SerialPortSettings|...
my bad, the signals are correctly working... checked it with the probe... maybe the buttons on the board bl-dt10 need to be removed...