nmakel

Hi Martin, thanks for the PR and explanation of your set-up. Wonderful to see this project made your install possible! I will have a look at the various bits you've...

So I'm debating whether this is the most effective way of getting P1 readings. The hardware required for this to work is the [P1 reader](https://www.zuidwijk.com/product/p1-reader-ethernet/), right? Why not interface with...

I also had a look at your p1-reader project and I suspect I understand the stack a little better. My gut says the mqtt device that you submitted a while...

> the hardware required are a 10k Ohm resistor & basic transitor to invert the signal. I use the hardware serial on a RPI to consume the P1 signal. I...

Hi! Here's a sample of the data I'm sending to the inverter (obtained from a SDM630 in single phase mode), which should give you an idea of the expected units:...

> Here you see in my week consumption 4.05 MWh which is a biiiiit too much ... > >  So this is probably a unit issue....

> Note, I assume the Energy shown in the screen is suppose to show the current meter value, not the daily number right? > > I'm feeding... Check your `p1_current`...

> I can say that I finally had 2 days that everything fully matched, import & export included. The trick was the setting of `timeout = .1` . > >...

Are you using the latest solaredge firmware, by the way? Just to confirm this still works on newer firmware -- I have mine locked to an older release.

Can you confirm the registers contain data?