minimosd-extra

minimosd-extra copied to clipboard

error entering font mode no data

1

I have the following OSD: https://www.banggood.com/3DR-Micro-OSD-For-APM2_5-2_6-2_8-Pixhawk-PX4-Flight-Controller-Mini-Quadcopter-FPV-p-980860.html?rmmds=myorder&cur_warehouse=CN minimosd-extra can be flashed successfully, but when I try to write the charset, the error: "error entering font mode no data", is shown. I...

ghost

Wrong UART speed for MWII protocol

10

Wrong UART speed for MWII protocol, it's 57600 instead of 115200. In case of MWII AUTOBAUD shouldn't be used. Looks like case is not related to current hardware (OZE32 board,...

pmarkiewicz

Home Direction arrow not consistent in pointing toward home

21

#### Issue details Home direction arrow often does not point toward home.....often is 180 deg out #### Version v942 Mavlink #### Board type http://www.readytoflyquads.com/micro-minimosd-pin-header-edition runnning pixhawk with Ardupilot firmware ####...

Hwurzburg

PX4 Messages not shown

3

#### Issue details MAVLINK Messages are no longer shown. They have started to disappear last year, probably due to a change on the PX4 side. #### Version 934 onward ####...

tops4u

ILS direction

6

ILS for plane is not working when you want to land in the same direction than for takeoff Planes generaly takes off and lands in the same direction (case of...

mric3412

sensors format configuration

1

Please describe sensors "format", "factor", "add" columns For me it shows voltage 0.12V, but should 12.2 FC - INAV, protocol MW

retif

LTM telemetry not working

1

#### Issue details I am trying to get this OSD working with LTM from Inav without success. I've tested different OSD versions, but each time it says "No Data". It's...

krzysiu4

OT- Min Voltage Warning(v) limited to 25.5 - request for 28v for 8s

1

#### Issue details Unable to set the "Min Voltage Warning(v)" value to something greater than 25.5. I fly 8s so really could do with a value greater that 28v if...

bionicbone

Incorrect battery readings after MINIMOSD power failure

1

Hi! When turning off and on the power of the MINIMOSD board (with the PIX autopilot constantly on), the battery level readings on the OSD screen become about 30% instead...

Gennadiy1990

#### Issue details With the last version of ardupilot with ELRS and original holybro PX4 board some times osd freezes and in gps data zone or show stream overload, also...

jorgeneo560