nibblerrick

I really would like to see this supported, too. I am running into the same issue.

Hi, I am in the same boat. I made a messy node-red-flow to use the mqtt-hvac for translating to the knx bus because the climate-thing wasn't doing that much. I...

> You can add an `expose` section in your KNX configuration, below example for my two sensors which I use to control the A/C unit fan speed and room ambient...

Same here.

This is the same that's done at the [openhab-dmx-plugin](https://www.openhab.org/addons/bindings/dmx/#thing-configuration) I think? They refenced [this document](https://poynton.ca/PDFs/SMPTE93_Gamma.pdf). If yes I would appreciate this, too, makes especially fading a light up much more...

> You can use a form + button to cause the URL to be opened in the current tab. Works well on browsers, although the official Jellyfin app for Android...

Nice that I am not the only one thinking of this. Multiple WLED-Strips with different effect-assignments is truely another level... But to be able "just" to sent out the config...

For me it worked just replacing the spaces with underscores (so would be `binary_sensor.530i_xdrive_condition_based_services.brake_fluid_status` in your case). I don't know if that's the designated way it shoudl be handled but...