neo-jayfeather

All current 0.6mm P1S profiles have 0.15 elephants foot compensation, however some print profiles are missing that, like the 0.16 high quality a1m profile has it set to 0, and...

https://wiki.bambulab.com/en/software/bambu-studio/parameter/elephant-foot The last two screenshots seem to indicate that BBL does not plan on fixing this issue on their slicer. Just a note, but this does seem fixable by editing...

I was reading the [prusaslicer](https://help.prusa3d.com/article/elephant-foot-compensation_114487) wiki and they stated that elephant's foot compensation should squish the filament out enough so that the brim should be properly aligned-- I don't know...