Andi Powers-Holmes
Andi Powers-Holmes
This is an issue on the LCSC/EasyEDA side Some of their STEP models are scaled so that 1 unit = 1 inch, KiCad expects 1 unit = 1cm You'll find...
Works with a LOLIN D1 Mini v3.0.0 using the v5.2.0 xtensa-lx106-elf package [from this link](https://dl.espressif.com/dl/xtensa-lx106-elf-linux64-1.22.0-100-ge567ec7-5.2.0.tar.gz), and tweaking the GPIO assignments / changing flash upload speed to 1,500,000 baud in menuconfig...
Awesome! @Yeah2333 thanks for confirming it works for you 😄 I also just submitted an order for some of these from JLCPCB, I expect it'll work just fine, there's not...
Awesome! My boards have shown up, but my miniware hotplate is broken at the moment so I've not been able to solder one together yet 😢 my attempts with a...
Ah, yes, you're right - I remembered the numbers wrong 😖 I've just checked the specification sheet I have from Delkin and the contact side is 2.1mm to the contact...
@EnumC Hmm, based on this teardown pic (via https://toptech.news/xbox-series-x-seagate-expansion-card-teardown/ ), there shouldn't be a gap - the recessed section of the casing on the left goes above the contacts: ...
> Well, according to `file` it is a valid gzip archive (and the decompressed size is under the `BOOTM_LEN` in uboot): > > ``` > $ file linux-custom/arch/mips/boot/vmlinux.bin.gz > linux-custom/arch/mips/boot/vmlinux.bin.gz:...
Thanks! I've mostly been finishing up work on another device (Sophos APX530) for the last few days, but with any luck I should get to working on this properly in...
I'm quite happy to help out with hardware-side testing on this stuff; the PHY hardware timestamping support is most of the reason I picked up a CM4+CM4IO board, and it...
FWIW, if all you want is for the shutdown button to work, this application is completely unnecessary. The button is on the standard/default shutdown pin, GPIO 3, so all you...