nateof8

Jan, I've been looking at Dan's conversion and it is quite clean. I did a gerber comparison layer by layer and found only minor differences which were explained in his...

Jan, I have finally completed a build (yes...just for fun) of Dan Chianucci's conversion into KiCad. It took nearly 6 months to receive my MAX2871s on backorder. There were a...

> Since you made changes to the latest public KiCad conversion (at least that is what I understood when skimming your change log), will you be making a pull request...

Here are the results of calibration. I only have inexpensive calibration standards, but hopefully this is still useful. [SOLT_1_100k-6_00G_4001pt.zip](https://github.com/user-attachments/files/19035093/SOLT_1_100k-6_00G_4001pt.zip)

Thanks for the analysis and suggestion. Looks like you nailed it! I found what looks to be a bad solder joint on the port one mixer input. I repaired and...

You are 2 for 2. I found another soldering issue on the output of the Port 2 front end mixer. It is very difficult to see unless it is at...

Awesome...thanks Jan and Dan! I only had about 6 screws holding the shield on temporarily while I was troubleshooting. Just for your peace of mind, I took another isolation after...

Here is the final isolation plot...it didn't come through via email. 

Jan...I've tested v0.3.0 and can confirm it has fixed all of the issues that I was experiencing. Thanks for taking the time to figure it out.