Ken Cox

It works on 0.8.2, 0.8.6, 0.8.7, and 0.8.8 but not on 0.9. I have tested on two phones (MI8 and Oppo A9), the result is the same.

What display are you using? in my case, I use CR10_STOCKDISPLAY so I added this just after the #define CR10_STOCKDISPLAY. You can put it in Configuration_adv.h or even in board...

Ender 3 stock display, if you will notice is the same CR10_STOCKDISPLAY. It is safe because there is no kill button/pin in Ender 3. Unless you want to wire a...

I think you need it inside #ifdef to avoid those warnig

I am able to build the bugfix 2.0.5.3, still need some fixes here and there. The sample configuration that comes with bugfix has bedpidtemp enabled. That could be another surprise...