Murk
Murk
+1 See also / not really a duplicate but related #3315
**Related issues:** - https://github.com/prusa3d/PrusaSlicer/issues/11615 - https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/3807 - https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/3583 Would likely be a bit trickier to implement with either a list of future tools required listed around every toolchange or at...
https://help.prusa3d.com/article/sd-cards-and-usb-drives_112291 The help page is a little bit confusing since it doesn't just explicitly say "use FAT32". It does say however exFAT is not supported, and that's correct: it's disabled...
Related issue but more about safety due to automated start / remote commands - https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/3315
Reproducible in 6.0.0. When directly inserting filament using autoload, the warning is not displayed. Additionally, inserting filament to trigger autoload and then removing it without doing anything clears the loaded...
@Prusa-Support Yes, this is when using the experimental menu. I don't believe MINTEMP errors would affect this issue since those are BSODs that require printer restarts (I believe at least?)...
The bug is still reproducible by setting speed to 8/255 and manually stopping the fan while reproducing step 5. I don't believe it is a major issue that frankly anyone...
To be clear, the actual fan speed is not relevant, using 8/255 is just to prevent sanding off my fingertips when stopping the fan to trigger the warning. As long...