Marko Grdinić
Marko Grdinić
I used `stack repl` from the command line to load it in interactive. Is that the same? In the task manager then I observed `ghc` occupying 2.35Gb. It was higher...
I've typed it in, but get something to the following effect. ``` C:\futhark\src>ghc-mod legacy-interactive :load futhark-pyopencl NG Invalid argument `:load'\n\nUsage: ``` I just get `NG Invalid argument` regardless of what...
I've tried it. I am not sure what it is supposed to be doing, but I do not think this command is working properly. It appears to me as if...
Tried it. I see it takes up 3,584Mb, which is close to the limit of what my system can afford. The check passed successfully.
I am not sure as it terminates, so I had not bothered to keep track of it yesterday. Looking at it now, `ghc-mod check src\futhark-pyopencl.hs` reaches a high of ~3,300Mb...
No, actually, the tests done now weren't from the version built from master. It is true that I built the project yesterday, but I then removed it due to it...
I just tested it with the 5.6.0.0 version. They peak around the same point in terms of memory usage. I just saw it reach 3,384Mb before finishing.
I think it does take up roughly 3.5Gb at first if I just let it load and do nothing even in Atom. It actually takes up more and crashes when...
I've tried the above. I think I now have a good idea of what is going on after working on this issue for so much. When the file first loads,...
@DanielG Let me make a update here since the discussion moved to the other issue page for a bit. @lierdakil did as I suggested in the post above and added...