Artem Rodichkin

Seems like: in order to run wifi, one need tft screen in LVGL UI mode. The only supported tft screen is TS35, which requires SPI flash to run in LVGL...

me stupid) using wifi adaptor is described here) https://github.com/makerbase-mks/MKS-SKIPR ssid and psk (wifi network name and password) sholud be modified in "wpa_supplicant-wlan0.conf" file on emmc) now on each reboot wifi...

ok issue was with both of my card readers and with default files on emmc. replaced with https://drive.google.com/drive/folders/1tTuSvF9OL2qtPXElau8YOXn2sWbdxa9e and ... it worked on first launch, but the second one -...

after connecting wifi module most issues relolved. connect to your local wifi from pi screen, connect keyboard to enter password to board. launch your rourer web panel to define board...

same problem, nothing connected to board, and touch screen is super unresponsive, basically unusable

update everything except moonraker in settings (bottom of the page), restart firmware

password is: makerbase

with ACC set to 1024 1000RPM achieved, but drivers burned(

Only 6 wires from driver to board - spep, dir, ebnable, ground, vcc, vin. So it seems sensorless homing not possible. This is a big problem for me as my...

Same, 4 drivers burned, literally (transistors near 4 output pins on both sides) Ma - 3000, ACC - 1024 vFOC