morxgrillhamster

I'm using UGS version 2.1.4 with GRBL 1.1h (lasted version) and have the same problem with the feedrate: it is far too low and when trying to cut out 2mm...

Here we go: (actually I changed the feed rate from 1200 to 800, it's less scary;-): (Exported by FreeCAD) (Post Processor: grbl_post) (Output Time:2024-01-16 11:21:15.316808) (Begin preamble) G17 G90 G21...

Thanks for looking into that. I did a quick check and with your suggestion it moves now much faster. Is the "Arc line segment length" a fixed small value independent...

Thanks a lot, that was very helpful, I found it. The original file had 160 lines, the generated file >23500 lines. For Windows users: use %TEMP%\17055... instead of /tmp/17055.... to...