Marcelo Bezerra

## Current Behavior If you load and apply Octo X8 mixer profile, you end up with 6 motors, instead of 8 ## Steps to Reproduce 1. Load Octo X8 mixer...

Add a template for new target PR

2

This is a test template for new target pull requests. This adds a checklist for target validation to the PR.

Use 2 bits for msp displayport font page

1

May allow for future 4 page fonts

Show calibration status of sensors on status output

1

## Current Behavior INAV status will show status OK for sensors that require calibration, even when they haven't been calibrated. This may result in navigation not being safe, and the...

GPS Model is not aligned wth North direction.

7

These pictures were taken in the alignment tool, with the gps in the same orientation (CW 270 FLIP) If the Arrow on the GPS is supposed to point North, it...

Allow LED pin to be reassigned as MOTOR or SERVO

1

Configurator counterpart to iNavFlight/inav#10022 This change requires corresponding firmware. * [x] Add LED to override options * [x] LED override option displayed correctly on loading * [x] LED override option...

Allow LED pin to be reassigned as MOTOR or SERVO

2

This is a continuation of timer output mapping, adding led pins to the pool. * [x] Add led option to timer_output_mode * [x] Show led option in diff * [x]...

Build ser2tcp as a universal binary

4

My Makefile fu is a bit rusty, but I believe this gets the job done. Also, clean had rm ~*, Was that a typo for *~?

Some users have reported issues with INAV 7.1+ when upgrading from previews versions in aircraft that had this gyro. Recalibrating the gyro, or redoing the setup in INAV 7.1 seems...

Add jitter reduction to serial gimbal

1

Add a deadband and possibility of skipping updates when there are no changes. ### gimbal_jitter_deadband How much position change needs to happen, before considering it different from last position. Having...