mkubi
mkubi
I applied 12v power, no USB is connected. I measured 12.4V between input terminas, however directly on driver there is just 3.06V
OK this is interesting: 1. flashed - 2nd ESP32 with old "GRBL_ESP32" firmware and motors are working. 2. switch to FLUIDNC 3.7.5 - motors are working for first time and...
[MSG:INFO: X Axis driver test passed] [MSG:INFO: Y Axis driver test passed] [MSG:INFO: Y2 Axis driver test passed] [MSG:INFO: Z Axis driver test passed] [MSG:INFO: Kinematic system: Cartesian] [MSG:INFO: Using...
It's interesting even $MI says driver not detected, but axes are moving when 1st test passed
[MSG:ERR: X Axis TMC driver not detected - expected 0x0x11 got 0x0x0] [MSG:ERR: Y Axis TMC driver not detected - expected 0x0x11 got 0x0x0] [MSG:ERR: Y2 Axis TMC driver not...
seems the microsteping has no effect. Looks like motor is moving same amount no matter what I configure.
I don't think this is HW related, reverted back to GRBL_ESP32 and it works fine.