Mike O'Connor

icon company OEG Australia icon location Lyndoch, South Australia

Results 4 comments of Mike O'Connor

timestamp

"Mon Jan _2 15:04:05 MST 2006" should work. Not tested

Richardjm/probe discard first

I also use something like this and feel its needed. First value from a probe cycle seem to always have a large difference from the following.

Orca is sending M106 commands to printer despitecode type is Klipper

M106 is a supported gcode in klipper as per https://www.klipper3d.org/G-Codes.html I suggest you do not have a part cooling fan configured, meaning klippper does not have M106 command.

System boots into grub rescue

I have the same problem, I was able to boot the system using the grub cli commands above (they where different. normal (hd{0,1}),gpt2)/efi//grub.cfg But I can not see how to...