minijouin

Are you sure ? Cause it's seems to be exactly the same ...

This is the good one to use ! http://www.conrad.fr/ce/fr/product/705866/Jack-35-mm-Embase-femelle-horizontale-Cliff-FC68133-Nombre-total-de-poles-4-stereo-noir-1-pcs/?ref=detview1&rt=detview1&rb=1

Yes it worked ! But then I ran "make install" and it failed... Do you know why ? The code is ending with "makefile:40: recipe for target "install" failed make:...

Target name : stm32f0x.cpu Type : cortex_m Endian : little TapName : stm32f0x.cpu State : unknown Is it related to the microchip stm32f030k6 ? What does .cpu mean ?

The error seems to be "Could not initialize the debug port" with that target

Error : Could not initialize the debug port Target Name : stm32j0x.cpu Type : Cortex_m Endian : little TapName : stm32f0x.cpu State : unknown adaptater speed : 101 kHz Error...

Thanks ! Yes, I checked everything. But I haven't put the jack connector yet, so it might be the reason !

Does anyone know how the STM should be placed ? Where does the dot should be placed exactly ? Because I actually think I've soldered it in the wrong direction.

Yes I know, I soldered it as it was on the images, but then I looked at the schematics, and into renders (>open-nsynth-super-bottom.pos) and it's written that U7 has to...

@elimuro did you find any solution ? I turned STM32f0x of 90° but I've got the same problem, still...