mikeinkl1

Struggled a bit with this myself, but got it to work eventually. The datasheets from Aliexpress are not necessarily correct, so it takes some trial and error. But if you...

Sure.. i got it from aliexpress and the pinout is in the description. Also see some of the reviews in the listing ... there seem to be 2 versions with...

 When it didnt work on the pi i tried with an esp8266... cheaper to replace if someting blows up.

BTW, display is a MHI-3.5 with a SPI to DPI converter chip from aliexpress. I think these are rated at 125MHz. It runs OK at 400/4=100MHz so far. Probably one...

All you need is on github. I got some pcbs from china and built a few. Firmware compiles OK now and works well. There isnt much case modding required either....

> I don't have a Retro-ESP32 either and I prefer to only release builds that I can personally test and troubleshoot when needed. But I can see the value in...

Did you compile it with wifi enabled?

> Hi, > > Today I spent some time examining the battery status. I connect GPIO36 to GND via 10k resistor, and to VCC via 10k resistor. I measured the...

Yes, main issue is probably the hardware, and this may be related the screen flicker and audio noise as well. Rolling average will help, but finding out why the launcher...

Yes.. I just unplugged the sd card and the flicker was still there. I dont think it is the wifi either as the flicker already occurred in the previous releases....