Michal Zahor

attaching logs, ELM bench. was described in another post

using Carista Bluetooth module

Yes, I did. It shows few red info that xml is not present for ECU and about 2 are not fully ok. But ABS was not mentioned there. I'll post...

Actualy I don’t understand why is there (ABS) status of ACC deacrivated by diag. What I’m tesing to achieve is to enable ACC and DW ( I’ve koleos where this...

Koleos is from end of september 2018. It has RaCam. I’ve enabled distance warning and is working correctly. I don’t have steering wheel with a button to change a distance...

Result of ECU scan  Each recognised ECU with relevant XML should be there listed ? Then the list is kind of short :-) In the terminal I see...

I've tried to increase timeout ( from Auto, to 600ms ) and I was able to write data. But then check ESP, check hill assist, warning in indicated . When...

I have modified Rlink fw 7.x only using development menu. In DDT4ALL there is only radnav 2.x and 3.x and I was worried about applying changes using DDT4ALL. In dev...

1. Is it safe to use for example RAdNat 3.x v3.3 in DDT4ALL if I have RLINK2 firmware 7.xx ? [ I see now your comment about RadNav_2* - ok...

Is it possible to save current ECU config or just write down original value ?