Mats Engstrom
Mats Engstrom
The Stella for Mac is a universal binary so it should work on both platforms, but you probably shouldn't have the x86/arm -folders then. Just a Darwin folder. But I...
I just tried it and it kinda works. It complains about needing a debugger for Dasm and suggest that I install "Dash macro assembler for VSCode" by Zen Fernando. After...
Never mind ^__^ I guess it was just a fluke or a PEBCAK. I uninstalled, deleted folders and restarted vs code and reinstalled ADS and it works just fine. **But!**...
I think this was resolved in the fix for issue #1331 which was another problem with the same component.
Hehe.. yes, not just only "nearly impossible" but I rather say "quite impossible" considering that in 1 ns a signal propagates like 160mm (half a foot) on a FR4 PCB....
Very NO-NO in general. Virtually the only case you can leave inputs floating is if you're using real 74**LS** ICs - they float quite stable to VCC and would work...
Hm... Maybe I didn't read your question thoroughly enough. You actually ask about pulling to VCC - basically whether to connect directly or via a resistor. Still for lab/home/echool usage...
Yes, for 74LS you don't "really" need resistors for pulls, you can safely connect directly to vcc/gnd. Also since 74LS have an internal pull up as a part of the...
If you follow the wires that gets highlighted in red the the error occurs you'll see that the `QA` outputs on the top two 74161 are connected a bit down...
Personally I'd be happy enough with having "busses" shown either thicker or with a differing color.