me0262

Solved. Issue pertains to newer SDKs using an XML project format (*.csproj) over the old project.json. This apparently was a hard change and was not transitioned out of dotnet. dotnet...

close when confirmed. this is a change that should be made in the repo (along with the edge-cs repo).

This is still an issue here. I print directly over USB, and it goes from "Printing to Canceling", and stays there until I end up doing a full system restart...

Cancelled a print (I'm having filament feed problems on some cardboard spools), and once again I'm forever canceling. The serial.log is quite long, so I'll give the relevant snippet. ```...

Same issue here. I have the exact same log lines where it's waiting for the unpause button while I'm doing a filament load. I believe this is a small power...

@SeanSnyders I'm getting this version conflict on Linux as well. I've resolved by 'npm install electron-rebuild' and running 'node_modules/.bin/electron-rebuild' This must be a problem on electron's side, because the latest...