OctoPrint-TFT
OctoPrint-TFT copied to clipboard
mcuadros
A OctoPrint touch interface for TFT touch modules based on GTK+3
The ui freezes during every single print, the web ui works, printing works, but the tft ui hangs after it comes back from screen saver and only a reboot helps....
OctoPrint TFT installation hangs up at this point. I have tried to reinstall on a fresh Image, this is a recreation after last failed install. Sorry if to much code...
I have a [PiTFT Plus 480x320 3.5" TFT+Touchscreen for Raspberry Pi](https://www.adafruit.com/product/2441). The screen was installed with the commands: `wget https://raw.githubusercontent.com/adafruit/Adafruit-PiTFT-Helper/master/adafruit-pitft-helper2.sh chmod +x adafruit-pitft-helper2.sh sudo ./adafruit-pitft-helper2.sh` The screen works perfectly fine,...
even though I have disabled screen blanking, after a while it does it anyway. If I touch the screen immediately , it will wake back up and work fine. If...
Is there any trick to installing this on pi64? It compiles from source okay, but we can do that without right?
the error message while i do refresh on the sd card files is: **unmarshaled number into go struct response.Free of type int** i use Octopi updated and upgraded to latest...
* minor grammatical changes * Addresses Issue #13 by pointing to the TFT installation instructions on the wiki page (Currently the wiki page is on my fork, I cannot access...