wideband

wideband copied to clipboard

Would it be possible to support NTK ZFAS-U2 as well?

rusefillc

Update wideband-can.dbc

2

message id for ecu to wb controller was wrong

TurboCorse

rusefillc

Start feeding pump before reaching target temperature (close loop). Otherwise if mixture is lean, nernst voltage is too close to virtual ground and voltage on output of differential op amp...

dron0gus

Old parameters in uart.cpp and linking error

7

Hello, I'm trying to use the serial debug functionnality on a custom standalone F0 board in order to debug a non-trivial heater state error. (over heated on closed loop after...

Theo-Point

I have this weird behaviour where the Nernst voltage is not regulated to 450 mV. See also: https://rusefi.com/forum/viewtopic.php?f=17&t=2740 Is there a way to debug the device, so I could specify...

ME12451

Does the firmware indicate version or compilation time via CAN bus? Maybe something along the lines of https://github.com/rusefi/libfirmware/blob/master/util/include/rusefi/manifest.h?

rusefillc

inputs are not protected

1

I've hooked up stm32f042 wideband module to a mis-wired cable. heater wire into into Vm has caused flowing red stm32f042

rusefillc

suggestion to improve naming

3

rusefillc

Weird behaviour of hand soldered F0 board runing latest firmware

2

Hello, I have two f0 boards which have two different behaviours, both running November firmware from mck1137/wideband. 1. Nerst voltage fluctuates depening on the applied oxygen (sensor over candle or...

dynfer