proteus
proteus copied to clipboard
mck1117
On the Proteus v0.7 board, the tle9201 power input does not have a suppressor Diode.  It seems that if the top pair of arms fails, then the reverse current...
Due to freewheeling diodes Vs can rise quite high with back-EMF. Do we need TVS to clamp it? Datasheet says we need.  
 Threshold voltage may be as high as 3.5V which is not reachable with 3.3V STM32 GPIO.
risk of people ordering 90% from JLC and not being able to source TLE9202 later
Neither of BOM files https://github.com/mck1117/proteus/tree/master/export/v0.7 contains BT1 part number?
The title block seems generic and the PCB does not reside within the title block boundaries. It seems odd to work off the side of the title block.
max9926 = exactly 2 * max9924, and is larger pitch so maybe easier to solder
I think it makes sense to give the option to route the USB signals to the white AMP connector. Replacing the (un-needed) grounds at pins 1-4. This would allow a...
Support for 2 wire speed sensors would only require a simple schematic. Simplest of schematics would be a 50 Ω low side resistor and an op-amp or Schmidt trigger to...
