maxoutny

Was reviewing the working config for the Root4 Lite and uncomment huanyang and uploaded it to the controller: # Begin Huanyang uart1: txd_pin: gpio.15 rxd_pin: gpio.16 rts_pin: gpio.14 baud: 9600...

rts_pin is not connected to VFD, not sure where to connect it

Changed config to: uart2: txd_pin: gpio.15 rxd_pin: gpio.16 rts_pin: gpio.14 baud: 9600 mode: 8N1 Huanyang: uart_num: 2 modbus_id: 1 tool_num: 0 speed_map: 0=0% 0=25% 6000=25% 24000=100% off_on_alarm: false After restarting...

My config is the same now, if I use uart1 I have an error, if I use uart2 in config no error but the spindle not starting. Changing the combination...

Thank you for the clear explanation. Updated my config: # Begin Huanyang uart1: txd_pin: gpio.15 rxd_pin: gpio.16 rts_pin: gpio.14 baud: 9600 mode: 8N1 Huanyang: uart_num: 1 modbus_id: 1 tool_num: 0...

io14 - blinking LED14 - is led up and off at the same time as io14 led. Found additional settings on VFD for Communication function parameters: F163 set to 1...

One more question about RS485 from controller to VFD what would be a proper setting for: 0- 8N1 for ASCII was 3- 8N1 for RTU? On Mon, Aug 5, 2024...

Yes, TY. Trying to much it with my settings on my VFD, my not PD... on my it is F.. On Mon, Aug 5, 2024 at 1:19 PM bdring ***@***.***>...