Matt Baker

Version 3.9.0 is being released which fixes issues related to ivyrep, please give it a try shortly when it is up.

Thanks for the comments and feedback. Quality changes were all made per the suggestions. Code was rebased onto master to fix merge conflicts in src/stm32/fdcan.c and flash_usb.py Let me know...

The G4 SWD change looks fine, that would explain why I needed to make `openocd` hold the device in reset before initiating programming. I didn't actually need to use the...

The i2c configurations for L4 look good now. 👍

Looks good to me other than the inline comment, and the f0 version worked effectively on the l4 previously. When I read "allowed" in the data sheet I get the...

Apologies, I thought the stm32f0_serial.c switchover was going to be more invasive and have been having trouble finding time. The latest push was loaded onto the device to retest and...

Merge date estimate sounds good. Went ahead and switched the files over to the 1.4.0 release. I did review the changes from 1.4.0 to 1.5.0 and they are very low...

I have some unique data that may be interesting to the conversation. Everything I have seen points to the mechanics of a printer with this issue needing the z motion...

> Interesting. Though, if this was the case, I'd expect to see it only on the first probe in a QUAD_GANTRY_LEVEL (or BED_MESH_CALIBRATE or Z_TILT_ADJUST) sequence. However, I've seen the...

> More tests. As can clearly be seen the first probe after moving back to CENTER is off in comparison. > > From the results here it certainly doesn't appear...