Marc Draco

Thanks! I guess someone with more time on their hands than I have might want to take it up. :) I'm too old to do much programming (or electronic design)...

Hi Sean, It's a TronXY Pro 2 with stock firmware - I can't put Marlin on there much as I'd like to. It's not that I'm unable, just that I...

Sure will. It's just completing a print so I'll do that as soon as it completes. For the money this is a well-featured and fairly well made printer (except that...

M503 just prints some numbers which I can only assume it's some non-Marlin or something broken beyond that... Foosel's fix notes as following during startup though if this helps. Repl:...

Ah! No sweat Sean... on sec. On snap - just comes out with the same hopeless message (CBD, not Foosel!) Send: N6 M115*32 Recv: ok CBD make it.Date:Nov 21 2019...

That's a LOT of g-code dude. How can I limit it to just the bits you need? I don't (currently) have any remaining prints showing that bug IRL as it...

Yeah, that's my take too. I have Cura set to do an auto-bed level each time it prints *just in case* something went pear shaped overnight, etc. And of course,...

Of course. I'll send something I know will go "wrong" after the current print finishes. I'll do a couple of tests to see if cylinders are affected too - I've...

As a movie guy (games are a secondary consideration for me, an important one though) I can see what the OP's getting at but I think they misunderstand how binocular...

I've seen similar behavior. The problem seems to lie with Python which isn't the fastest language around. Always seemed an odd choice to me for this sort of thing. There...