makermoekoe

What do mean with brick two of the Picoclicks? How do they behave now? Regarding ESPHome, may the configuration file for the device could help here. How do you want...

> I had the same problem with a few new C3's, albeit programmed via Arduino IDE. > I believe the problem was that I was accidentally pulling up GPIO9 (boot)....

> This is the basic ESPHome conf that I'm trying to run on the PicoClick C3: Then you probably don't toggle the latch and the Picoclick looses power with releasing...

Well, the battery divider is not needed when don't care about the battery state. It's there to read the batteries voltage level und thus estimate the state of the battery...

For the first version of the Picoclick (not the C3 version) I tried to connect the voltage divider to a GPIO on the GND side and turn it low while...

> > For the first version of the Picoclick (not the C3 version) I tried to connect the voltage divider to a GPIO on the GND side and turn it...

Especially the idea behind the third link looks very interesting! Just a short period of time to take the measurement but that should be fine, I like it. I will...

Ouuh yes! It works. This problem finally made me buy an oscilloscope 😄 I received it yesterday and initially tested it with the third point of your list above. It...

How time flies 😰 But yes I have worked on it for the last two months! Not sure if you're following on Instagram, but my latest board (the purple Paperclick...

Don't know why it is looking for arduino.map, because it isn't used anywhere in the code. Or did you add something? What might help is to delete your platformIO packages...